Precautions For The Use of PTEF Mesh Belt

How to adjust the deviation of the PTFE grid conveyor belt
1. Automatic drag roller deviation adjustment: When the deviation range of the mesh belt is not too large, a self-aligning drag roller can be installed at the conveyor belt deviation.
2. Appropriate tightening and deviation adjustment: When the conveyor belt deviates from left to right, and the direction is irregular, it indicates that the conveyor belt is too loose. The tensioning device can be adjusted appropriately to eliminate the deviation.
3. Adjust the roller deviation: the PTFE mesh belt runs off the roller, check whether the roller is abnormal or move, adjust the roller to the horizontal position and rotate normally to eliminate the deviation.
4. Correct the conveyor belt joint deviation; the conveyor belt deviation is always in one direction, and the maximum deviation is at the joint. The conveyor belt joint and the conveyor belt center line can be corrected to eliminate the deviation. The PTFE grid conveyor belt should be stored in a dry In this case, of course, part of this is the problem of the manufacturer, but in the daily work process, it is necessary to liquidate and protect the maintenance belt on time.

Above, I told everyone about the problems that are easy to ignore in daily life.
1. Avoid damp in the electromechanical. When the mesh belt is stored in the open air, rainproof measures should be taken. During storage and handling, the mesh belt should be prevented from bumping, so as to avoid damage to the mesh belt and keep the surface clean.
2. The usage of the PTFE mesh belt should always be kept clean and tidy. There should be no debris at the air inlet and outlet. Eliminate dust and other debris in the mesh belt and pipes on schedule, and keep the power supply measures adequate.
3. Do not replenish or change the lubricating grease on the bearing according to the conditions of use. (It is not necessary to change the lubricating grease during the service life of the electromechanical closed bearing) in order to ensure the superior lubrication of the mesh belt during operation. Close the bearing and the electromechanical bearing. Fill 2/3 of the inner and outer rings of the bearing with ZL-3 lithium grease. It is strictly forbidden to run out of oil. To ensure safety, stop the machine for inspection immediately.

PTFE film has the characteristics of low temperature resistance, and its friction coefficient is extremely low, so it can be used for lubrication and become an ideal coating for easy cleaning of the inner layer of water pipes.